Take-Over of Renkum PM 2 signed
The PM 2 of Parenco in Renkum, Netherlands, was successfully started up just 14 months after contract signing. After a short optimization phase the customer signed the official take-over document.
This rebuild increases the mill’s capacity by approximately 385,000 metric tons annually.
“We are pleased that the take-over has been signed. In the next months, we will proof that Parenco is a new supplier in the packaging paper industry” says Geert Wassens, CEO of Parenco.
The conversion from newsprint to packaging paper grades will help to position Parenco as a highly competitive supplier in the packaging paper market, and broadens its paper making activities. Since 2012, Parenco is an independent company under the ownership of H2. Beside the converted PM 2, Parenco operates also the PM 1 in Renkum, which produces magazine paper (SCB) for the European market.
After start-up the rebuilt PM 2
Just after start-up the rebuilt PM 2 already proved that the produced paper quality reaches the market demands on all points.
With a wire width of 8.4 m the paper machine was equipped with a new two-layer MasterJet Pro M2 headbox, a DuoFormer D II, a DuoCentri NipcoFlex press, a SpeedFlow sizing unit and a new CombiDuoRun after dryer section. The PM 2 produces Testliner and Fluting in a basis weight range of 70 to160 g/m².
Voith did not only rebuild the paper machine itself: Within the Process Line Package scope, Voith as general contractor also adjusted and rebuilt all adjacent processes and utilities. This also included a new OCC stock preparation and the Wet End Process. Based on the results of a pre-engineering, the scope of supply also covered all necessary adaptions on the steam, water and power supply as well as civil works.
